|
|
Trouble Shooting |
| Parking Sensor |
Problem & Solution:
1.No display when reversing:
-Make sure power on, reversing light on
-Make sure power cable connected control box with correct pole
-Make sure display screen cables connected control box correctly
2.Display but no buzz:
-Stop buzz automatically if connecting the VDI module
-The screen cable connected to G socket of VDI module
3.Wrong digital display:
-Other pressure car washing nearby, or another parking sensor is working
-Make sure sensor installed not facing to the ground
-Check the turning face of sensor, not inclined or even upside down
-Check all plugs and joints connected firmly
4.Ceaseless ticktack from radar without obstacles:
-Other pressure car washing nearby, or another parking sensor is working
-Something higher than sensor on the car
-Obstacles besides the car
-Make sure sensor installed not facing to the ground
-Check the turning face of sensor, not inclined or even upside down
-Try to reduce sensibility, put pin to low position
-Something wrong with sensor
5.Low sensibility:
-Heavy silt on the sensor
-Check all plugs and joints connected firmly
-Abnormal power voltage
-Set higher sensibility
6.Two different digital display:
-Two obstacles
-Obstacle moving
7.Re-start often:
-Poor contact of power
8.Sometimes good and sometimes bad:
-Check all plugs and joints connected firmly
9.Digital display when raining:
-Detect raindrop if rain is heavy
10.Digital display on the snow:
-Detect snow if the snow is much higher than the ground
Notice:
The Parking sensor system is strictly a driver assistant device. It should not be considered safety device for any purposes. Manufacturer and distributors of the product do not guarantee or assume liability for collision or damages that take place when backing up your vehicle.
| |
|
